LAN9211 datasheet(38/147 Pages) SMSC

38 / 147 page

High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support

Datasheet

Revision 2.9 (03-01-12)

SMSC LAN9211

DATASHEET

If an operation is attempted, and an EEPROM device does not respond within 30mS, the LAN9211

will timeout, and the EPC timeout bit (EPC_TO) in the E2P_CMD register will be set.

Figure 3.10, "EEPROM Access Flow Diagram" illustrates the host accesses required to perform an

EEPROM Read or Write operation.

The host can disable the EEPROM interface through the GPIO_CFG register. When the interface is

disabled, the EEDIO and ECLK signals can be used as general-purpose outputs, or they may be used

to monitor internal MII signals.

3.9.2.1

Supported EEPROM Operations

The EEPROM controller supports the following EEPROM operations under host control via the

E2P_CMD register. The operations are commonly supported by “93C46” EEPROM devices. A

description and functional timing diagram is provided below for each operation. Please refer to the

E2P_CMD register description in Section 5.3.23, "E2P_CMD – EEPROM Command Register," on

page 101 for E2P_CMD field settings for each command.

Figure 3.10 EEPROM Access Flow Diagram

Idle

Write Data

Write

Command

Read

Command

Busy Bit = 0

Idle

Write

Command

Read

Command

Read Data

Busy Bit = 0

EEPROM Write

EEPROM Read

LAN9211 데이터시트(PDF) 38 Page - SMSC Corporation