STM32F411RET6 datasheet(67/149 Pages) STMICROELECTRONICS

67 / 149 page

DocID026289 Rev 6

67/149

STM32F411xC STM32F411xE

Electrical characteristics

123

6.3.6

Supply current characteristics

The current consumption is a function of several parameters and factors such as the

operating voltage, ambient temperature, I/O pin loading, device software configuration,

operating frequencies, I/O pin switching rate, program location in memory and executed

binary code.

The current consumption is measured as described in Figure 18: Current consumption

measurement scheme.

All the run-mode current consumption measurements given in this section are performed

with a reduced code that gives a consumption equivalent to CoreMark code.

Typical and maximum current consumption

The MCU is placed under the following conditions:

•

All I/O pins are in input mode with a static value at VDD or VSS (no load).

•

All peripherals are disabled except if it is explicitly mentioned.

•

The Flash memory access time is adjusted to both fHCLK frequency and VDD ranges

(refer to Table 15: Features depending on the operating power supply range).

•

The voltage scaling is adjusted to fHCLK frequency as follows:

–

Scale 3 for fHCLK ≤ 64 MHz

–

Scale 2 for 64 MHz < fHCLK ≤ 84 MHz

–

Scale 1 for 84 MHz < fHCLK ≤ 100 MHz

•

The system clock is HCLK, fPCLK1 = fHCLK/2, and fPCLK2 = fHCLK.

•

External clock is 4 MHz and PLL is ON except if it is explicitly mentioned.

•

The maximum values are obtained for VDD = 3.6 V and a maximum ambient

temperature (TA), and the typical values for TA= 25 °C and VDD = 3.3 V unless

otherwise specified.

IRUSH(2)

In-Rush current on

voltage regulator power-

on (POR or wakeup from

Standby)

160

200

ERUSH(2)

In-Rush energy on

voltage regulator power-

on (POR or wakeup from

Standby)

VDD = 1.7 V, TA = 125 °C,

IRUSH = 171 mA for 31 µs

5.4

µC

1. The product behavior is guaranteed by design down to the minimum VPOR/PDR value.

2. Guaranteed by design.

3. The reset timing is measured from the power-on (POR reset or wakeup from VBAT) to the instant when first

instruction is fetched by the user application code.

Table 19. Embedded reset and power control block characteristics (continued)

Symbol

Parameter

Conditions

Min

Typ

Max

Unit

STM32F411RET6 데이터시트(PDF) 67 Page - STMicroelectronics

STM32F411RET6 데이터시트(HTML) 67 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL