SC2200 datasheet(13/433 Pages) NSC

13 / 433 page

Revision 3.0

www.national.com

Architecture Overview (Continued)

GX_BASE+8404h-8407h

MC_MEM_CNTRL2 (R/W)

Reset Value: 00000801h

31:14

RSVD (Reserved). Write as 0.

13:12

SDCLKCTL (SDCLK High Drive/Slew Control). Controls the high drive and slew rate of SDCLK[3:0] and SDCLK_OUT.

11 is strongest, 00 is weakest.

RSVD (Reserved). Write as 0.

SDCLKOMSK# (Enable SDCLK_OUT). Turns on the output.

0: Enable.

1: Disable.

SDCLK3MSK# (Enable SDCLK3). Turns on the output.

0: Enable.

1: Disable.

SDCLK2MSK# (Enable SDCLK2). Turns on the output.

0: Enable.

1: Disable.

SDCLK1MSK# (Enable SDCLK1). Turns on the output. 0

0: Enable.

1: Disable.

SDCLK0MSK# (Enable SDCLK0). Turns on the output.

0: Enable.

1: Disable.

5:3

SHFTSDCLK (Shift SDCLK). This function allows shifting SDCLK to meet SDRAM setup and hold time requirements. The

shift function will not take effect until the SDCLKSTRT bit (bit 17 of MC_MEM_CNTRL1) transitions from 0 to 1:

000: No shift

100: Shift 2 core clocks

001: Shift 0.5 core clock

101: Shift 2.5 core clocks

010: Shift 1 core clock

110: Shift 3 core clocks

011: Shift 1.5 core clock

111: Reserved

RSVD (Reserved). Write as 0.

RD (Read Data Phase). Selects if read data is latched one or two core clock after the rising edge of SDCLK.

0: 1 Core clock.

1: 2 Core clocks.

FSTRDMSK (Fast Read Mask). Do not allow core reads to bypass the request FIFO.

0: Disable.

1: Enable.

GX_BASE+8408h-840Bh

MC_BANK_CFG (R/W)

Reset Value: 41104110h

31:16

RSVD (Reserved). Write as 0070h

RSVD (Reserved). Write as 0.

SODIMM_MOD_BNK (SODIMM Module Banks - Banks 0 and 1). Selects number of module banks installed per SODIMM

for SODIMM:

0: 1 Module bank (Bank 0 only)

1: 2 Module banks (Bank 0 and 1)

RSVD (Reserved). Write as 0.

SODIMM_COMP_BNK (SODIMM Component Banks - Banks 0 and 1). Selects the number of component banks per

module bank for SODIMM:

0: 2 Component banks

1: 4 Component banks

Banks 0 and 1 must have the same number of component banks.

RSVD (Reserved). Write as 0.

10:8

SODIMM_SZ (SODIMM Size - Banks 0 and 1). Selects the size of SODIMM:

000: 4 MB

010: 16 MB

100: 64 MB

110: 256 MB

001: 8 MB

011: 32 MB

101: 128 MB

111: 512 MB

This size is the total of both banks 0 and 1. Also, banks 0 and 1 must be the same size.

RSVD (Reserved). Write as 0.

Table 1-2. SC2200 Memory Controller Registers (Continued)

Bit

Description

SC2200 데이터시트(PDF) 13 Page - National Semiconductor (TI)

SC2200 데이터시트(HTML) 13 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL