| 전자부품 데이터시트 검색엔진 |
|
PC97338VLJ 데이터시트(PDF) 69 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
PC97338VLJ 데이터시트(HTML) 69 Page - National Semiconductor (TI) |
|
69 / 221 page ![]() 69 www.national.com 3.0 The Digital Floppy Disk Controller (FDC) The Floppy Disk Controller (FDC) is suitable for all PC-AT, EISA, PS/2, and general purpose applica- tions. DP8473 and N82077 software compatibility is provided. Key features include a 16-byte FIFO, PS/2 diagnostic register support, perpendicular recording mode, CMOS disk input and output logic, and a high performance Digital Data Separator (DDS). Figure 41shows a functional block diagram of the FDC. The rest of this Section describes the FDC func- tions, data transfer, the FDC registers, the phases of FDC commands, the result phase status registers and the FDC commands, in that order. 3.1 FDC FUNCTIONS The Chip is software compatible with the DP8473 and 82077 Floppy Disk Controllers (FDCs). Upon a pow- er-on reset, the 16-byte FIFO is disabled. Also, the disk interface output signals are configured as active push-pull output signals, which are compatible with both CMOS input signals and open-collector resistor terminated disk drive input signals. The FIFO can be enabled with the CONFIGURE command. The FIFO can be very useful at high data rates, with systems that have a long DMA bus latency, or with multi-task- ing systems such as the EISA or MCA bus structures. The FDC supports all the DP8473 MODE command features as well as some additional features. These include control over the enabling of the FIFO for read and write operations, disabling burst mode for the FIFO, a bit that will configure the disk interface out- puts as open-drain output signals, and programmabil- ity of the DENSEL output signal. 3.1.1 Microprocessor Interface The FDC interface to the microprocessor consists of the A9-3, AEN, RD, and WR signals, which access the chip for read and write operations; the data sig- nals D7-0; the address lines A2-0, which select the appropriate register (see Table 35); the IRQ6 signal, and the DMA interface signals DRQ, DACK, and TC. It is through this microprocessor interface that the Floppy Disk Controller (FDC) receives commands, transfers data, and returns status information. FIGURE 41. FDC Functional Block Diagram Internal Control and Data Bus Interface Logic Address Decoder DMA Enable Logic Main Status Register 16-Byte FIFO (MSR) PC8477B Micro-Engine and Timing/Control Logic Data Rate Selection Register (DSR) Configuration Control Register (CCR) 2 KB x 16 Micro-Code Status Register A Status Register B Digital Input Register (DIR) Digital Output Register (DOR) Write Precompen- Digital Data Separator (DDS) Disk Input and Output Logic DRATE1,0 DENSEL DIR DR1 DR23 HDSEL MTR0 sator MTR1 STEP WGATE WDATA DSKCHG DRV2 INDEX RDATA TRK0 WP MSEN1,0 RD FDC Chip WR A2-0 Reset D7-0 FDC DMA TC FDC DMA Interrupt FDC Clock Select Acknowledge Request DR0 |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |