STV2050A datasheet(51/83 Pages) STMICROELECTRONICS

51 / 83 page

51/83

STV2050A - CONVERGENCE

The STV2050A can generate a special convergence signal (cursor) controlled by the GCD bit

in the E3 register.

TThe cursor action is selected by the DHV bit in the E3 register.

During field offset measuring lines, the values applied to the DACs for each channel are given

by the MVR[7:0] bits for red, MVG[7:0] bits for green and MVB[7:0] bits for blue in the E8 reg-

ister.

In vertical cursor mode, the resulting values applied to the DACs are first positive, then in-

verted on the following TV line. In horizontal mode, the values are inverted at each TV line.

Figure 27. Gain Cursors

When using this mode, the STV2050A must be correctly set in order to recognize the inter-

laced field. The IIE bit in the DA register must be set to 1.

9.8 CONVERGENCE OUTPUTS

The values of the six convergence channels are converted by 14-bit DACs with a differential

current output.

GCD

0 = Cursor Off

1 = Cursor On

DHV

0 = Horizontal Cursor

1 = Vertical Cursor

n’

-A

Vertical Gain Adjustment

Horizontal Gain Adjustment

n’

n’+4

n’+2

n’+1

n’+3

n+1

n+3

n+4

n+2

- A

+ A

n+5

Middle of

Video Grid

(Odd)

n+1

(Even)

(Odd)

STV2050A 데이터시트(PDF) 51 Page - STMicroelectronics

STV2050A 데이터시트(HTML) 51 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83

데이터시트 다운로드

링크 URL