STM32F410RB datasheet(31/142 Pages) STMICROELECTRONICS

31 / 142 page

DocID028094 Rev 5

31/142

STM32F410x8/B

Functional overview

•

Triangular-wave generation

•

DMA capability for each channel

•

External triggers for conversion

•

Sample and hold low-power mode, with internal or external capacitor

The DAC channel is triggered through TIM6 update output that is also connected to different

DMA channels.

3.30

Serial wire JTAG debug port (SWJ-DP)

The ARM SWJ-DP interface is embedded, and is a combined JTAG and serial wire debug

port that enables either a serial wire debug or a JTAG probe to be connected to the target.

Debug is performed using 2 pins only instead of 5 required by the JTAG (JTAG pins could

be re-use as GPIO with alternate function): the JTAG TMS and TCK pins are shared with

SWDIO and SWCLK, respectively, and a specific sequence on the TMS pin is used to

switch between JTAG-DP and SW-DP.

3.31

Embedded Trace Macrocell™

The ARM Embedded Trace Macrocell provides a greater visibility of the instruction and data

flow inside the CPU core by streaming compressed data at a very high rate from the

STM32F410x8/B through a small number of ETM pins to an external hardware trace port

analyzer (TPA) device. The TPA is connected to a host computer using any high-speed

channel available. Real-time instruction and data flow activity can be recorded and then

formatted for display on the host computer that runs the debugger software. TPA hardware

is commercially available from common development tool vendors.

The Embedded Trace Macrocell operates with third party debugger software tools.

STM32F410RB 데이터시트(PDF) 31 Page - STMicroelectronics