PIC12CE673-04SLASHP datasheet(34/116 Pages) MICROCHIP

34 / 116 page

PIC12CE67X

DS40181B-page 34

Preliminary

7.3

Prescaler

An 8-bit counter is available as a prescaler for the

Timer0 module, or as a postscaler for the Watchdog

Timer, respectively (Figure 7-6). For simplicity, this

counter is being referred to as “prescaler” throughout

this data sheet. Note that there is only one prescaler

available which is mutually exclusively shared between

the Timer0 module and the Watchdog Timer. Thus, a

prescaler assignment for the Timer0 module means

that there is no prescaler for the Watchdog Timer, and

vice-versa.

The PSA and PS2:PS0 bits (OPTION<3:0>) determine

the prescaler assignment and prescale ratio.

When assigned to the Timer0 module, all instructions

writing to the TMR0 register (e.g. CLRF 1, MOVWF 1,

BSF 1,x

....etc.) will clear the prescaler. When assigned

to WDT, a CLRWDT instruction will clear the prescaler

along with the Watchdog Timer. The prescaler is not

readable or writable.

FIGURE 7-6:

BLOCK DIAGRAM OF THE TIMER0/WDT PRESCALER

GP2/T0CKI/

T0SE

AN2/INT

CLKOUT (=Fosc/4)

SYNC

Cycles

TMR0 reg

8-bit Prescaler

8 - to - 1MUX

M U X

Watchdog

Timer

PSA

WDT

Time-out

PS2:PS0

Note: T0CS, T0SE, PSA, PS2:PS0 are (OPTION<5:0>).

PSA

WDT Enable bit

Data Bus

Set ﬂag bit T0IF

on Overﬂow

PSA

T0CS

PIC12CE673-04/P 데이터시트(PDF) 34 Page - Microchip Technology

PIC12CE673-04/P 데이터시트(HTML) 34 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL