LPC47M14X datasheet(62/205 Pages) SMSC

62 / 205 page

SMSC DS – LPC47M14X

Page 62

Rev. 05/02/2000

Bit 4,5

Reserved

Bit 6,7

These bits are used to set the trigger level for the RCVR FIFO interrupt.

INTERRUPT IDENTIFICATION REGISTER (IIR)

Address Offset = 2H, DLAB = X, READ

By accessing this register, the host CPU can determine the highest priority interrupt and its source. Four levels of

priority interrupt exist. They are in descending order of priority:

1) Receiver Line Status (highest priority)

2) Received Data Ready

3) Transmitter Holding Register Empty

4) MODEM Status (lowest priority)

Information indicating that a prioritized interrupt is pending and the source of that interrupt is stored in the Interrupt

Identification Register (refer to Interrupt Control Table). When the CPU accesses the IIR, the Serial Port freezes all

interrupts and indicates the highest priority pending interrupt to the CPU. During this CPU access, even if the Serial Port

records new interrupts, the current indication does not change until access is completed. The contents of the IIR are

described below.

Bit 0

This bit can be used in either a hardwired prioritized or polled environment to indicate whether an interrupt is pending.

When bit 0 is a logic "0", an interrupt is pending and the contents of the IIR may be used as a pointer to the appropriate

internal service routine. When bit 0 is a logic "1", no interrupt is pending.

Bits 1 and 2

These two bits of the IIR are used to identify the highest priority interrupt pending as indicated by the Interrupt Control

Table.

Bit 3

In non-FIFO mode, this bit is a logic "0". In FIFO mode this bit is set along with bit 2 when a timeout interrupt is pending.

Bits 4 and 5

These bits of the IIR are always logic "0".

Bits 6 and 7

These two bits are set when the FIFO CONTROL Register bit 0 equals 1.

Bit 7

Bit 6

RCVR FIFO

Trigger Level (BYTES)

LPC47M14X 데이터시트(PDF) 62 Page - SMSC Corporation