ST7LUS5 datasheet(90/124 Pages) STMICROELECTRONICS

90 / 124 page

Electrical characteristics

ST7LUS5, ST7LU05, ST7LU09

90/124

Electrical characteristics

12.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

12.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by

the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and represent the

mean value plus or minus three times the standard deviation (mean ± 3

Σ).

12.1.2

Typical values

Unless otherwise specified, typical data is based on TA = 25°C, VDD = 5V (for the

4.5V < VDD < 5.5V voltage range) and VDD = 3.3V (for the 3V < VDD < 3.6V voltage range).

They are given only as design guidelines and are not tested.

12.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

12.1.4

Loading capacitor

The loading conditions used for pin parameter measurement are shown in Figure 35.

Figure 35.

Pin loading conditions

ST7 PIN

ST7LUS5 데이터시트(PDF) 90 Page - STMicroelectronics