HC705RC17GRSSLASHD datasheet(49/126 Pages) NXP

49 / 126 page

Resets

Internal Resets

MC68HC705RC17 — Rev. 2.0

General Release Specification

Resets

5.5.2 Computer Operating Properly Reset (COPR)

The MCU contains a watchdog timer that automatically times out if not

reset (cleared) within a specific time by a program reset sequence. If the

COP watchdog timer is allowed to time out, an internal reset is

generated to reset the MCU. Regardless of an internal or external reset,

the MCU comes out of a COP reset according to the standard rules of

mode selection.

The COP reset function is enabled or disabled by a mask option and is

verified during production testing.

5.5.2.1 Resetting the COP

Writing a 0 to the COP bit prevents a COP reset. This action resets the

counter and begins the time out period again. The COP bit is bit 0 of

address $3FF0. A read of address $3FF0 returns user data programmed

at that location.

5.5.2.2 COP During Wait Mode

The COP continues to operate normally during wait mode. The software

should pull the device out of wait mode periodically and reset the COP

by writing to the COPF bit to prevent a COP reset.

5.5.2.3 COP During Stop Mode

When the stop enable mask option is selected, stop mode disables the

oscillator circuit and thereby turns the clock off for the entire device.

When stop is executed, the COP counter will hold its current state. If a

reset is used to exit stop mode, the COP counter is reset and held until

4064 POR cycles are completed at which time counting will begin. If an

external IRQ is used to exit stop mode, the COP counter does not wait

for the completion of the 4064 POR cycles but does count these cycles.

Therefore, it is recommended that the COP is fed before executing the

STOP instruction.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705RC17GRS/D 데이터시트(PDF) 49 Page - NXP Semiconductors