STE10A datasheet(28/82 Pages) STMICROELECTRONICS

28 / 82 page

Functional description

STE10/100A

28/82

3.8

Wake on LAN function

The STE10/100A can assert a signal to wake up the system when it has received a Magic

Packet from the network. The wake on LAN operation is described as follow.

The Magic Packet format

–

Valid destination address that can pass the address filter of the STE10/100A

–

Payload of the frame including at least 6 contiguous ‘FF’ followed immediately by

16 repetitions of IEEE address

–

The frame can contain multiple ‘six FF + sixteen IEEE address’ pattern

–

Valid CRC

The wake on LAN operation

The wake on LAN enable function is controlled by WOL (bit 18 of CSR18), which is loaded

from EEPROM after reset or programmed by driver software. If WOL is set and the

STE10/100A receives a Magic Packet, it will assert the PME# signal (active low) to indicate

reception of a wake up frame and will set the PME status bit (bit 15 of CSR20).

3.9

ACPI power management function

The STE10/100A has a built-in capability for power management (PM) which is controlled by

the host system.

The STE10/100A will provide:

–

Compatibility with device class power management reference specification

–

Network device class, draft proposal v0.9, october 1996

–

Compatibility with ACPI, Rev 1.0, december 22, 1996

–

Compatibility with PCI bus power management interface specification, Rev 1.0,

january 6, 1997

–

Compatibility with AMD Magic Packet™ Technology.

3.9.1

Power states

DO (Fully on)

In this state the STE10/100A operates with full functionality and consumes normal power.

While in the D0 state, if the PCI clock is lower than 16MHz, the STE10/100A may not

receive or transmit frames properly.

D1, D2, and D3hot

In these states, the STE10/100A doesn’t respond to any accesses except configuration

space and full function context in place. The only network operation the STE10/100A can

initiate is a wake-up event.

D3cold (Power removed)

In this state all function context is lost. When power is restored, a PCI reset must be

asserted and the function will return to D0.

STE10A 데이터시트(PDF) 28 Page - STMicroelectronics

STE10A 데이터시트(HTML) 28 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

데이터시트 다운로드

링크 URL