PM7344 datasheet(107/293 Pages) PMC

107 / 293 page

PM7344 S/UNI-MPH

DATA SHEET

PMC-950449

ISSUE 6

MULTI-PHY USER NETWORK INTERFACE

PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE

high causes the S/UNI-MPH to drive the data bus and holding the CSB pin

low tri-states the data bus. The DBCTRL bit overrides the HIZDATA bit. The

DBCTRL bit is used to measure the drive capability of the data bus driver

pads.

IOTST:

The IOTST bit is used to allow normal microprocessor access to the test

registers and control the test mode in each block in the S/UNI-MPH for board

level testing. When IOTST is a logic 1, all blocks are held in test mode and

the microprocessor may write to a block's test mode 0 registers to manipulate

the outputs of the block and consequently the device outputs (refer to the

"Test Mode 0 Details" in the "Test Features" section).

HIZIO,HIZDATA:

The HIZIO and HIZDATA bits control the tri-state modes of the S/UNI-MPH .

While the HIZIO bit is a logic 1, all output pins of the S/UNI-MPH except the

data bus are held in a high-impedance state. The microprocessor interface is

still active. While the HIZDATA bit is a logic 1, the data bus is also held in a

high-impedance state which inhibits microprocessor read cycles.

PM7344 데이터시트(PDF) 107 Page - PMC-Sierra, Inc