PWR-2700-DC-R datasheet(77/80 Pages) ARISTA

77 / 80 page

Maintenance and Field Replacement

2. Match the six screws on the Touch Point Shield to the holes on the chassis and screw in the Touch

Point Shield).

Figure 48: Installing the Touch Point Shield (7512N)

1 ESD port

3 Ground cable going up

2 Ground cable going down

F.4

Supervisor Module

The supervisor modules are hot-swappable. They are accessible from the front of the switch. You must

take into account that the module you are inserting is compatible with the switch and the module that

you are replacing. Use the following procedure to remove and replace a supervisor module. For the

supervisor module locations for your device, refer to Front Panel.

F.4.1

Removing Supervisor Module Blank

The fabric module blank is screwed on. Use the appropriate screwdriver for your switch.

1. Put on a grounded, anti-static ESD strap.

2. Unscrew the blank from the fabric module slot you are going to populate.

You may want to save the blank for future use as needed. The blank is needed for the switch to

operate normally if a fabric module slot is not populated.

F.4.2

Removing Supervisor Module

Perform the following steps to remove the module.

1. Put on a grounded ESD strap.

2. Pinch ejector buttons on handles or levers on each end of the supervisor card.

3. Spread the ejector buttons on the handles outwards.

4. Pull the supervisor module out by the ejector buttons on the handles of the supervisor card.

5. Slide supervisor module out of the slot.

PWR-2700-DC-R 데이터시트(PDF) 77 Page - Arista Networks, Inc