PWR-2700-DC-R datasheet(15/80 Pages) ARISTA

15 / 80 page

Chapter

Rack Mounting the Switch

The following topics are covered in this section:

•

7504N and 7508N Rack Mounting

•

7512N and 7516N Shelf Rack Mount Installation

The accessory kit provides components for installing the switch in two-post and four-post racks.

•

Two-Post Rack Mount provides instructions for mounting the switch in a two-post rack.

•

Four-Post Rack Mount provides instructions for mounting the 7504N and 7508N switches in a four-

post rack.

•

7512N and 7516N Shelf Rack Mount Installation provides instructions for mounting the 7512N and

the 7516N switches in a shelf four-post rack.

The rack mounting procedure is identical for the 7504N and 7508N Series switches. Illustrations in this

chapter depict the mounting of an unpopulated 8-slot chassis.

The 7512N and the 7516N switches require a different mounting shelf, and only for the four-post

rack. Illustrations in this chapter depict the mounting of an unpopulated 12-slot chassis and a 16-slot

chassis.

After completing the instructions for your rack type, proceed to Cabling the Modular Switch.

3.1

7504N and 7508N Rack Mounting

3.1.1

Two-Post Rack Mount

To mount the switch to a two-post rack, assemble mounting brackets to the middle of the chassis, then

attach the brackets to the rack. The switch does not support a front or rear mount into a two-post rack.

The accessory kit includes the following two-post mounting parts:

•

2 - center-mount brackets

•

20 - M4x8 pan-head Phillips screws

3.1.1.1

Attaching Mounting Brackets to the Chassis

1. Orient the switch chassis and the two center-mount brackets (Figure 2: Attaching the Center-mount

Brackets).

Position the flanges that attach to the rack posts toward the rear of the chassis.

2. Attach both center-mount brackets to the chassis. Each bracket requires ten M4x8 pan-head

Phillips screws.

PWR-2700-DC-R 데이터시트(PDF) 15 Page - Arista Networks, Inc