TMP86FS28DFG datasheet(38/272 Pages) TOSHIBA

38 / 272 page

Page 26

2. Operational Description

2.2 System Clock Controller

TMP86FS28DFG

• Start the IDLE0 and SLEEP0 modes

Stop (Disable) peripherals such as a timer counter.

To start IDLE0 and SLEEP0 modes, set SYSCR2<TGHALT> to “1”.

• Release the IDLE0 and SLEEP0 modes

IDLE0 and SLEEP0 modes include a normal release mode and an interrupt release mode.

These modes are selected by interrupt master flag (IMF), the individual interrupt enable flag

of TBT and TBTCR<TBTEN>.

After releasing IDLE0 and SLEEP0 modes, the SYSCR2<TGHALT> is automatically

cleared to “0” and the operation mode is returned to the mode preceding IDLE0 and SLEEP0

modes. Before starting the IDLE0 or SLEEP0 mode, when the TBTCR<TBTEN> is set to “1”,

INTTBT interrupt latch is set to “1”.

IDLE0 and SLEEP0 modes can also be released by inputting low level on the RESET pin.

After releasing reset, the operation mode is started from NORMAL1 mode.

Note: IDLE0 and SLEEP0 modes start/release without reference to TBTCR<TBTEN> setting.

(1)

Normal release mode (IMF

•EF6•TBTCR<TBTEN> = “0”)

IDLE0 and SLEEP0 modes are released by the source clock falling edge, which is setting by the

TBTCR<TBTCK>. After the falling edge is detected, the program operation is resumed from the

instruction following the IDLE0 and SLEEP0 modes start instruction. Before starting the IDLE0 or

SLEEP0 mode, when the TBTCR<TBTEN> is set to “1”, INTTBT interrupt latch is set to “1”.

(2) Interrupt release mode (IMF

•EF6•TBTCR<TBTEN> = “1”)

IDLE0 and SLEEP0 modes are released by the source clock falling edge, which is setting by the

TBTCR<TBTCK> and INTTBT interrupt processing is started.

Note 1: Because returning from IDLE0, SLEEP0 to NORMAL1, SLOW1 is executed by the asynchro-

nous internal clock, the period of IDLE0, SLEEP0 mode might be the shorter than the period set-

ting by TBTCR<TBTCK>.

Note 2: When a watchdog timer interrupt is generated immediately before IDLE0/SLEEP0 mode is

started, the watchdog timer interrupt will be processed but IDLE0/SLEEP0 mode will not be

started.

TMP86FS28DFG 데이터시트(PDF) 38 Page - Toshiba Semiconductor