FS32K142HAT0MLHT datasheet(30/84 Pages) NXP

30 / 84 page

Table 17. External System Oscillator electrical specifications

(continued)

Symbol

Description

Min.

Typ.

Max.

Unit

Notes

High-gain mode (HGO=1)

—

MΩ

RS3

Series resistor

Low-gain mode (HGO=0)

—

kΩ

High-gain mode (HGO=1)

—

kΩ

Vpp_XTAL Peak-to-peak amplitude of oscillation (oscillator mode) at XTAL

Low-gain mode (HGO=0)

—

1.0

—

High-gain mode (HGO=1)

—

3.3

—

Vpp_EXTAL Peak-to-peak amplitude of oscillation (oscillator mode) at EXTAL

Low-gain mode (HGO=0)

0.8

—

High-gain mode (HGO=1), VDD= 4.0 V to 5.5 V

1.7

—

VSOSCOP Oscillation operating point

High-gain mode (HGO=1)

1.15

—

1. Crystal oscillator circuit provides stable oscillations when gmXOSC > 5 * gm_crit. The gm_crit is defined as:

gm_crit = 4 * (ESR + RS) * (2πF)2 * (C0 + CL)2

where:

• gmXOSC is the transconductance of the internal oscillator circuit

• ESR is the equivalent series resistance of the external crystal

• RS is the series resistance connected between XTAL pin and external crystal for current limitation

• F is the external crystal oscillation frequency

• C0 is the shunt capacitance of the external crystal

• CL is the external crystal total load capacitance. CL = Cs+ [C1*C2/(C1+C2)]

• Cs is stray or parasitic capacitance on the pin due to any PCB traces

• C1, C2 external load capacitances on EXTAL and XTAL pins

See manufacture datasheet for external crystal component values

• When low-gain is selected, internal RF will be selected and external RF should not be attached.

• When high-gain is selected, external RF (1 M Ohm) needs to be connected for proper operation of the crystal. For

external resistor, up to 5% tolerance is allowed.

3. RS should be selected carefully to have appropriate oscillation amplitude for both protecting crystal or resonator device and

satisfying proper oscillation startup condition.

4. The EXTAL and XTAL pins should only be connected to required oscillator components and must not be connected to any

other devices.

6.2.2 External System Oscillator frequency specifications

Clock interface modules

S32K1xx Data Sheet, Rev. 9, 09/2018

NXP Semiconductors

FS32K142HAT0MLHT 데이터시트(PDF) 30 Page - NXP Semiconductors

FS32K142HAT0MLHT 데이터시트(HTML) 30 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

데이터시트 다운로드

링크 URL