PIC16F15213 datasheet(64/408 Pages) MICROCHIP

64 / 408 page

10.3.2

MCLR Disabled

When MCLR is disabled, the MCLR becomes input-only and pin functions such as internal weak pull-ups are under

software control.

10.4

Watchdog Timer (WDT) Reset

The Watchdog Timer generates a Reset if the firmware does not issue a CLRWDT instruction within the time-out

period. The TO, PD and RWDT bits are changed to indicate a WDT Reset caused by the timer overflowing.

10.5

RESET Instruction

A RESET instruction will cause a device Reset. The RI bit will be set to ‘0’. See Table 10-4 for default conditions after

a RESET instruction has occurred.

10.6

Stack Overflow/Underflow Reset

The device can reset when the Stack Overflows or Underflows. The STKOVF or STKUNF bits indicate the Reset

condition. These Resets are enabled by setting the STVREN bit.

10.7

Power-up Timer (PWRT)

The Power-up Timer provides up to a 64 ms time-out period on POR or Brown-out Reset. The device is held in Reset

as long as PWRT is active. The PWRT delay allows additional time for the VDD to rise to an acceptable level.

The Power-up Timer is controlled by the PWRTS bits. The Power-up Timer starts after the release of the POR and

BOR. For additional information, refer to Application Note AN607, “Power-up Trouble Shooting” (DS00000607).

10.8

Start-up Sequence

Upon the release of a POR or BOR, the following must occur before the device will begin executing:

Power-up Timer runs to completion (if enabled).

MCLR must be released (if enabled).

The Power-up Timer runs independently of MCLR Reset. If MCLR is kept low long enough, the Power-up Timer will

expire. Upon bringing MCLR high, the device will begin execution after ten FOSC cycles (see Figure 10-3). This is

useful for testing purposes or for synchronizing more than one device operating in parallel.

PIC16F15225/45

Resets

Preliminary Datasheet

DS20006389B-page 64

PIC16F15213 데이터시트(PDF) 64 Page - Microchip Technology