GP32SLASH2 datasheet(9/44 Pages) CLARKE

9 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

KNOW YOUR GENERATOR

LOW IDLE

This generator is equipped with a low idle switch.

Engaging this switch allows the system to regulate the

engine speed and automatically adjust its fuel

consumption to match the required load. When the

electrical load changes, the generator engine will

automatically speed up and slow down as needed. This

reduces fuel consumption and noise levels, while

extending runtime and the engines lifespan.

Keep this switch engaged (ON) only when the power load

requirement is less than 75% of the rated watts. DO NOT

engage the switch when the total load is more than 75%

of rated watts. The generator engine must run at full

speed to supply power for anything over 75% of rated

watts.

PARALLEL OPERATION

The parallel operation outlet allows you to

connect two of these generators together

to increase the total available electrical

power. Follow the instructions included

with the parallel operation kit for correct

installation and operation.

NOTE: The Parallel Operation Kit is not

supplied with this generator.

Contact your CLARKE dealer for more information.

CIRCUIT BREAKERS

The circuit breakers protect the

individual AC and DC circuits. The AC

circuit breaker will activate when the AC

outlets exceed their maximum current.

The DC circuit breaker will activate when

the DC 12V and/or 5V USB outlet exceed

their maximum current. When the circuit

breaker activates, turn off and

disconnect the device(s) from the respective outlets and press the circuit breaker to

reset.

NOTE: The 31A circuit breaker may activate if there is a power issue with the

13A circuits. This is so that all circuits are protected in case of a power

GP32/2 데이터시트(PDF) 9 Page - Clarke International