GP32SLASH2 datasheet(15/44 Pages) CLARKE

15 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

terminal disconnected to maximise safety. To start the generator using the

electric start, the battery must be connected.

To connect the battery, follow these steps:

1. Loosen the screws to the right side

maintenance cover. Remove cover

and set aside.

2. Connect the red wire to the positive

(+) terminal first, then connect the black wire to the negative (-) terminal. Make

sure all connections are tight.

NOTE: Be careful not to short across the terminals when installing. Shorting

the terminals together can cause sparks, damage the battery and/or

generator and can cause burns or explosions.

3. Reinstall and secure the maintenance cover.

NOTE: If you do not plan to use the generator for a long period of time, we

recommend to disconnect the negative (black, ‘-’) battery cable from the

battery to protect the battery from losing charge. After disconnecting

the cable, cover the free end with an insulator such as electrical tape.

You may also choose to use a trickle charger (not included) to maintain

battery charge.

STEP 4 - GROUND THE GENERATOR

To reduce the risk of electric shock and to maximise safety, the generator

should be properly grounded.

Ground the generator by connecting a grounding

wire to the grounding nut on the front control

panel and tighten. A generally acceptable ground-

ing wire is a No.14 SWG (Standard Wire Gauge)

stranded copper wire.

This grounding wire should be connected at the

other end to a copper, brass or steel grounding rod

that is driven into the earth. Wire and grounding

rods are not included with the generator.

NOTE: Grounding codes can vary by location. Contact a local electrician to

check the area codes.

GP32/2 데이터시트(PDF) 15 Page - Clarke International