MK50H27PLCC datasheet(41/56 Pages) STMICROELECTRONICS

41 / 56 page

4.4.8 MK50H27 Internal Self Test

The MK50H27 contains an easy to use internal self test designed to test, with a high fault coverage, all

of the major blocks of the device except the DMA controller. It is suggested that a loopback test also be

performed to more completely test the DMA controller.

The following procedure should be followed to execute the internal self test:

1. Reset the device using the RESET pin.

2. Set bit 04 of CSR4.

3. Issue a Self Test Request through CSR1.

4. Poll CSR1, waiting for the PAV bit in CSR1 to be set by the MK50H27.

5. After the PAV bit is set, read CSR1. The success or failure of the test is indicated in the PPRIM field

as follows:

PPRIM

RESULT

Passed self test.

Failed the reset test of the self test.

Failed the self test in the micro controller RAM.

Failed the self test in the ALU.

Failed the self test in the timers.

Failed the self test in the transmitter and/or receiver.

Failed the self test in the CSR’s and/or bus master.

Otherwise

Failed device.

6. If the PAV bit is not set within 75 msec (SYSCLK = 10MHZ), then the MK50H27 is unable to respond

to the Self Test Request and will not complete successfully.

If the self test passes, then it may be immediately reexecuted from step 3, otherwise re-execution

should proceed from step 1.

MK50H27

41/56

MK50H27PLCC 데이터시트(PDF) 41 Page - STMicroelectronics