ST10F167 datasheet(64/69 Pages) STMICROELECTRONICS

64 / 69 page

64/69

ST10F167

Figure 20.15 CLKOUT and READY

Notes 1:Cycle as programmed, including MCTC waitstates (Example shows 0 MCTC WS).

2:The leading edge of the respective command depends on RW-delay.

3:READY sampled HIGH at this sampling point generates a READY controlled waitstate,

READY sampled LOW at this sampling point terminates the currently running bus cycle.

4:READY may be deactivated in response to the trailing (rising) edge of the corresponding com-

mand (RD or WR).

5:If the Asynchronous READY signal does not fulfil the indicated setup and hold times with respect

to CLKOUT (e.g. because CLKOUT is not enabled), it must fulfil

t37 in order to be safely syn-

chronized. This is guaranteed, if READY is removed in response to the command (see Note 4)).

6:Multiplexed bus modes have a MUX waitstate added after a bus cycle, and an additional MTTC

waitstate may be inserted here.

For a multiplexed bus with MTTC waitstate this delay is 2 CLKOUT cycles, for a demultiplexed

bus without MTTC waitstate this delay is zero.

7:The next external bus cycle may start here.

CLKOUT

ALE

t34

Sync

READY

Async

READY

waitstate

READY

MUX/Tristate 6)

Running cycle 1)

Command

RD, WR

see 6)

ST10F167 데이터시트(PDF) 64 Page - STMicroelectronics