SH7052 datasheet(95/919 Pages) RENESAS

95 / 919 page

5.4.2

Interrupt Priority Level

The interrupt priority order is predetermined. When multiple interrupts occur simultaneously

(overlap), the interrupt controller (INTC) determines their relative priorities and starts up

processing according to the results.

The priority order of interrupts is expressed as priority levels 0 to 16, with priority 0 the lowest

and priority 16 the highest. The NMI interrupt has priority 16 and cannot be masked, so it is

always accepted. The user break interrupt and H-UDI interrupt priority level is 15. IRQ interrupts

and on-chip peripheral module interrupt priority levels can be set freely using the INTC’s interrupt

priority registers A, C to L (IPRA, IPRC to IPRL) as shown in table 5.8. The priority levels that

can be set are 0 to 15. Level 16 cannot be set. See section 6.3.1, Interrupt Priority Registers A, C

to L (IPRA, IPRC to IPRL), for details of the interrupt priority registers.

Table 5.8

Interrupt Priority Order

Type

Priority Level

Comment

NMI

Fixed priority level. Cannot be masked.

User break

Fixed priority level.

IRQ

0 to 15

Set with interrupt priority level setting registers A

and C through L (IPRA, IPRC to IPRL).

On-chip peripheral module

0 to 15

Set with interrupt priority level setting registers A

and C through L (IPRA, IPRC to IPRL).

5.4.3

Interrupt Exception Processing

When an interrupt occurs, its priority level is ascertained by the interrupt controller (INTC). NMI

is always accepted, but other interrupts are only accepted if they have a priority level higher than

the priority level set in the interrupt mask bits (I3 to I0) of the status register (SR).

When an interrupt is accepted, exception processing begins. In interrupt exception processing, the

CPU saves SR and the program counter (PC) to the stack. The priority level value of the accepted

interrupt is written to SR bits I3 to I0. For NMI, however, the priority level is 16, but the value set

in I3 to I0 is H'F (level 15). Next, the start address of the exception service routine is fetched from

the exception processing vector table for the accepted interrupt, that address is jumped to and

execution begins. See section 6.4, Interrupt Operation, for further details.

SH7052 데이터시트(PDF) 95 Page - Renesas Technology Corp