SH7708 datasheet(135/633 Pages) RENESAS

135 / 633 page

117

6.4

INTC Operation

6.4.1

Interrupt Sequence

The sequence of interrupt operations is explained below. Figure 6.3 is a flowchart of the

operations.

1. The interrupt request sources send interrupt request signals to the interrupt controller.

2. The interrupt controller selects the highest priority interrupt from the interrupt requests sent,

following the priority levels set in interrupt priority registers A and B (IPRA and IPRB).

Lower priority interrupts are held pending. If two of these interrupts have the same priority

level or if multiple interrupts occur within a single module, the interrupt with the highest

default priority or the highest priority within its IPR setting unit (as indicated in table 6.4) is

selected.

3. The priority level of the interrupt selected by the interrupt controller is compared with the

interrupt mask bits (I3–I0) in the status register (SR) of the CPU. If the request priority level is

higher than the level in bits I3–I0, the interrupt controller accepts the interrupt and sends an

interrupt request signal to the CPU. When the interrupt controller receives an interrupt, a low

level is output from the

IRQOUT pin.

4. The CPU receives an interrupt at a break in instructions.

5. The interrupt source code is set in the interrupt event register (INTEVT).

6. The status register (SR) and program counter (PC) are saved to SSR and SPC, respectively.

7. The block bit (BL), mode bit (MD), and register bank bit (RB) in SR are set to 1.

8. The CPU jumps to the start address of the interrupt handler (the sum of the value set in the

vector base register (VBR) and H'00000600). The interrupt handler may branch with the

INTEVT register value as its offset in order to identify the interrupt source. This enables it to

branch to the handling routine for the individual interrupt source.

Notes: 1. The interrupt mask bits (I3–I0) in the status register (SR) are not changed by

acceptance of an interrupt in the SH7708 Series.

IRQOUT outputs a low level until the interrupt request is cleared. However, if the

interrupt source is masked by an interrupt mask bit, the

IRQOUT pin returns to the

high level. The level is output without regard to the BL bit.

3. The interrupt source flag should be cleared in the interrupt handler. To ensure that an

interrupt request that should have been cleared is not inadvertently accepted again, read

the interrupt source flag after it has been cleared, then wait for the interval shown in

table 6.6 (Time for priority decision and SR mask bit comparison) before clearing the

BL bit or executing an RTE instruction.

SH7708 데이터시트(PDF) 135 Page - Renesas Technology Corp