7733 datasheet(108/940 Pages) RENESAS

108 / 940 page

KEY INPUT INTERRUPT FUNCTION

7733 Group User’s Manual

5–5

(1) Port P6 pull-up selection bit (bit 5)

____

When using pin P64/INT2 as an input pin for the key input interrupt, set this bit to “1.” When this bit

____

is set to “1,” pin P64/INT2 is pulled high.

(2) Port P5 pull-up selection bit (bit 6)

___

This is a bit to pull pins KI0 to KI3 high. When configuring a key matrix, there is no need to connect

___

pull-up transistors externally if this bit is set to “1,” in other words, if pins KI0 to KI3 are set to be pulled

high.

(3) Key input interrupt selection bit (bit 7)

This is a bit to select the key input interrupt function.

____

The key input interrupt and the INT2 interrupt share the same interrupt vector addresses and interrupt

control register. When this bit is set to “1,” the key input interrupt function is selected. When this bit

____

= “1” and bit 5 (Port P6 pull-up selection bit) = “0,” pin P64/INT2 is a programmable I/O port. (At this

____

time, the INT2 interrupt cannot be used.) When both of this bit and bit 5 (Port P6 pull-up selection bit

____

1) are “1,” pin P64/INT2 can be used for the key input interrupt.

5.2 Block description

7733 데이터시트(PDF) 108 Page - Renesas Technology Corp