7733 datasheet(294/940 Pages) RENESAS

294 / 940 page

A-D CONVERTER

7733 Group User’s Manual

9–29

9.8.2 Operation in repeat sweep mode

Figure 9.8.2 shows the conversion operation in the repeat sweep mode.

(1) When internal trigger is selected

When the A-D conversion start flag is set to “1,” the A-D converter starts A-D conversion for an input

voltage of pin AN0.

The A-D conversion for pin AN0 is completed when one of the following conditions is satisfied, and

then the contents of the successive approximation register (in other words, the conversion result)

is transferred to the A-D register 0.

•49 cycles of

φAD have passed when resolution = 8 bits

•59 cycles of

φAD have passed when resolution = 10 bits

A-D conversion is performed for all analog input pins selected. Each time A-D conversion is completed

for a pin, the conversion result is transferred to the A-D register i which corresponds to the pin.

A-D conversion is repeatedly performed for all analog input pins selected.

The A-D converter continues operating until the A-D conversion start flag is cleared to “0” by

software.

(2) When external trigger is selected

______

If pin ADTRG’s level goes from “H” to “L” when the A-D conversion start flag = “1,” the A-D converter

starts A-D conversion for the input voltage of pin AN0.