ATtiny5 datasheet(36/168 Pages) ATMEL

36 / 168 page

8127C–AVR–10/09

ATtiny4/5/9/10

0x000B

RESET: ldi

r16, high(RAMEND); Main program start

0x000C

out

SPH,r16

; Set Stack Pointer

0x000D

ldi

r16, low(RAMEND) ; to top of RAM

0x000E

out

SPL,r16

0x000F

sei

; Enable interrupts

0x0010

<instr>

...

9.2

External Interrupts

External Interrupts are triggered by the INT0 pin or any of the PCINT3..0 pins. Observe that, if

enabled, the interrupts will trigger even if the INT0 or PCINT3..0 pins are configured as outputs.

This feature provides a way of generating a software interrupt. Pin change 0 interrupts PCI0 will

trigger if any enabled PCINT3..0 pin toggles. The PCMSK Register controls which pins contrib-

ute to the pin change interrupts. Pin change interrupts on PCINT3..0 are detected

asynchronously, which means that these interrupts can be used for waking the part also from

sleep modes other than Idle mode.

The INT0 interrupt can be triggered by a falling or rising edge or a low level. This is set up as

shown in “EICRA – External Interrupt Control Register A” on page 37. When the INT0 interrupt is

enabled and configured as level triggered, the interrupt will trigger as long as the pin is held low.

Note that recognition of falling or rising edge interrupts on INT0 requires the presence of an I/O

clock, as described in “Clock System” on page 17.

9.2.1

Low Level Interrupt

A low level interrupt on INT0 is detected asynchronously. This means that the interrupt source

can be used for waking the part also from sleep modes other than Idle (the I/O clock is halted in

all sleep modes except Idle).

Note that if a level triggered interrupt is used for wake-up from Power-down, the required level

must be held long enough for the MCU to complete the wake-up to trigger the level interrupt. If

the level disappears before the end of the Start-up Time, the MCU will still wake up, but no inter-

rupt will be generated. The start-up time is defined as described in “Clock System” on page 17.

If the low level on the interrupt pin is removed before the device has woken up then program

execution will not be diverted to the interrupt service routine but continue from the instruction fol-

lowing the SLEEP command.

9.2.2

Pin Change Interrupt Timing

A timing example of a pin change interrupt is shown in Figure 9-1.

ATtiny5 데이터시트(PDF) 36 Page - ATMEL Corporation

ATtiny5 데이터시트(HTML) 36 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL