ATmega64A datasheet(41/392 Pages) ATMEL

41 / 392 page

8160C–AVR–07/09

ATmega64A

8.6

External RC Oscillator

For timing insensitive applications, the external RC configuration shown in Figure 8-4 can be

used. The frequency is roughly estimated by the equation f = 1/(3RC). C should be at least 22

pF. By programming the CKOPT Fuse, the user can enable an internal 36 pF capacitor between

XTAL1 and GND, thereby removing the need for an external capacitor.

Figure 8-4.

External RC Configuration

The Oscillator can operate in four different modes, each optimized for a specific frequency

range. The operating mode is selected by the fuses CKSEL3:0 as shown in Table 8-5.

When this Oscillator is selected, start-up times are determined by the SUT Fuses as shown in

Table 8-6.

Note:

1. This option should not be used when operating close to the maximum frequency of the device.

Table 8-5.

External RC Oscillator Operating Modes

CKSEL3:0

Frequency Range (MHz)

0101

0.1 - 0.9

0110

0.9 - 3.0

0111

3.0 - 8.0

1000

8.0 - 12.0

Table 8-6.

Start-up Times for the External RC Oscillator Clock Selection

SUT1:0

Start-up Time from

Power-down and

Power-save

Additional Delay from

Reset

CC = 5.0V)

Recommended Usage

18 CK

–

BOD enabled

18 CK

4.1 ms

Fast rising power

18 CK

65 ms

Slowly rising power

6 CK(1)

4.1 ms

Fast rising power or BOD enabled

XTAL2

XTAL1

GND

VCC

ATmega64A 데이터시트(PDF) 41 Page - ATMEL Corporation

ATmega64A 데이터시트(HTML) 41 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL