C6416 datasheet(95/134 Pages) TI1

95 / 134 page

SMJ320C6414, SMJ320C6415, SMJ320C6416

FIXEDPOINT DIGITAL SIGNAL PROCESSORS

SGUS050A − JANUARY 2004 − REVISED MARCH 2004

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251−1443

SYNCHRONOUS DRAM TIMING (CONTINUED)

ECLKOUTx

CEx

ABE[7:0] or BBE[1:0]

AEA[12:3] or BEA[10:1]

AED[63:0] or BED[15:0]

AEA13 or BEA11

AOE/SDRAS/SOE‡

ARE/SDCAS/SADS/SRE‡

AWE/SDWE/SWE‡

AEA[22:14] or BEA[20:12]

BE1

BE2

BE3

BE4

Bank

Column

READ

PDT§

† These C64x devices have two EMIFs (EMIFA and EMIFB). All EMIFA signals are prefixed by an “A” and all EMIFB signals are prefixed by a

“B”. Throughout the rest of this document, in generic EMIF areas of discussion, the prefix “A” or “B” may be omitted [e.g., the synchronous DRAM

memory access signals are shown as generic ( SDCAS, SDWE, and SDRAS ) instead of ASDCAS, ASDWE, and ASDRAS (for EMIFA) and

BSDCAS, BSDWE, and BSDRAS (for EMIFB)].

‡ ARE/SDCAS/SADS/SRE, AWE/SDWE/SWE, and AOE/SDRAS/SOE operate as SDCAS, SDWE, and SDRAS, respectively, during SDRAM

accesses.

§ PDT signal is only asserted when the EDMA is in PDT mode (set the PDTS bit to 1 in the EDMA options parameter RAM). For PDT read, data

is not latched into EMIF. The PDTRL field in the PDT control register (PDTCTL) configures the latency of the PDT signal with respect to the data

phase of a read transaction. The latency of the PDT signal for a read can be programmed to 0, 1, 2, or 3 by setting PDTRL to 00, 01, 10, or 11,

respectively. PDTRL equals 00 (zero latency) in Figure 27.

Figure 27. SDRAM Read Command (CAS Latency 3) for EMIFA and EMIFB†

C6416 데이터시트(PDF) 95 Page - Texas Instruments