SPEAR1310 datasheet(30/57 Pages) STMICROELECTRONICS

30 / 57 page

USB Host controller (UHC)

SPEAr1310

30/57

Doc ID 17528 Rev 4

USB Host controller (UHC)

17.1

Main features

The USB 2.0 Host controller has 2 physical ports that are fully compliant with the Universal

Serial Bus specification (version 2.0), and provides an interface to the industry-standard

AHB bus.

The main features of the UHC are:

●

A PHY interface implementing a USB 2.0 transceiver macro-cell interface plus (UTMI+)

fully compliant with UTMI+ specification (revision 1.0), to execute serialization and de-

serialization of transmissions over the USB line

●

Either 30 MHz clock for 16-bit interface or 60 MHz for 8-bit interface supported by the

UTMI + PHY interface

●

A USB 2.0 Host controller (UHC) connected to the AHB bus that generates the

commands for the UTMI+PHY

●

Complies with both the enhanced host controller interface (EHCI) specification (version

1.0) and the open host controller interface (OHCI) specification (version 1.0a)

●

The UHC supports the 480 Mbps high-speed (HS) for USB 2.0 through an embedded

EHCI Host Controller, as well as the 12 Mbps full-speed (FS) and the 1.5 Mbps low-

speed (LS) for USB 1.1 through one integrated OHCI Host controller

●

All clock synchronization is handled within the UHC

●

An AHB slave for each controller (1 EHCI and 1 OHCI), acting as programming

interface to access to control and status registers

●

An AHB master for each controller (1 EHCI and 1 OHCI) for data transfer to system

memory, supporting 8-, 16-, and 32-bit wide data transactions on the AHB bus

●

32-bit AHB bus addressing

SPEAR1310 데이터시트(PDF) 30 Page - STMicroelectronics