WM8940CGEFLSLASHV datasheet(49/91 Pages) WOLFSON

49 / 91 page

Production Data

WM8940

PD, Rev 4.3, November 2011

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R56

Mono mixer

control

MONOATTN

Attenuation control for bypass path

(output of input boost stage) to mono

mixer input

0 = 0dB

1 = -10dB

MONOMUTE

0=No mute

1=Output muted. During mute the mono

output will output VMID which can be

used as a DC reference for a

headphone out.

AUX2MONO

Output of Auxilary amplifier to mono

mixer input:

0 = not selected

1 = selected

BYP2MONO

Bypass path (output of input boost

stage) to mono mixer input

0 = non selected

1 = selected

DAC2MONO

Output of DAC to mono mixer input

0 = not selected

1 = selected

Table 37 Mono Mixer Control

ENABLING THE OUTPUTS

Each analogue output of the WM8940 can be separately enabled or disabled. The analogue mixer

associated with each output has a separate enable. All outputs are disabled by default. To save

power, unused parts of the WM8940 should remain disabled.

Outputs can be enabled at any time, but it is not recommended to do so when BUFIO is disabled

(BUFIOEN=0), as this may cause pop noise (see “POP Minimisation” section).

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

Power

management 1

BIASEN

Analogue amplifiers bias enable

BUFIOEN

VMID buffer enable

Power

management 3

MONOEN

MONOOUT enable

SPKNEN

SPKOUTN enable

SPKPEN

SPKOUTP enable

MONOMIXEN 0

Mono mixer enable

SPKMIXEN

Speaker Mixer enable

Note:

All “Enable” bits are 1 = ON, 0 = OFF

Table 38 Output Stages Power Management Control

UNUSED ANALOGUE INPUTS/OUTPUTS

Whenever an analogue input/output is disabled, it remains connected to AVDD/2 through a resistor.

This helps to prevent pop noise when the output is re-enabled. The resistance between the voltage

buffer and the output pins can be controlled using the VROI control bit. The default impedance is

low, so that any capacitors on the outputs can charge up quickly at start-up. If a high impedance is

desired for disabled outputs, VROI can then be set to 1, increasing the resistance to about 30k

.

WM8940CGEFL/V 데이터시트(PDF) 49 Page - Wolfson Microelectronics plc

WM8940CGEFL/V 데이터시트(HTML) 49 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91

데이터시트 다운로드

링크 URL