M68ICS08GR datasheet(137/408 Pages) FREESCALE

137 / 408 page

Computer Operating Properly (COP)

Monitor Mode

MC68HC908GR8 — Rev 4.0

Technical Data

MOTOROLA

Computer Operating Properly (COP)

137

9.7 Monitor Mode

When monitor mode is entered with VTST on the IRQ pin, the COP is

disabled as long as VTST remains on the IRQ pin or the RST pin. When

monitor mode is entered by having blank reset vectors and not having

VTST on the IRQ pin, the COP is automatically disabled until a POR

occurs.

9.8 Low-Power Modes

The WAIT and STOP instructions put the MCU in low power-

consumption standby modes.

9.8.1 Wait Mode

The COP remains active during wait mode. To prevent a COP reset

during wait mode, periodically clear the COP counter in a CPU interrupt

routine.

9.8.2 Stop Mode

Stop mode turns off the CGMXCLK input to the COP and clears the COP

prescaler. Service the COP immediately before entering or after exiting

stop mode to ensure a full COP timeout period after entering or exiting

stop mode.

To prevent inadvertently turning off the COP with a STOP instruction, a

configuration option is available that disables the STOP instruction.

When the STOP bit in the configuration register has the STOP

instruction disabled, execution of a STOP instruction results in an illegal

opcode reset.

9.9 COP Module During Break Mode

The COP is disabled during a break interrupt when VTST is present on

the RST pin.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

M68ICS08GR 데이터시트(PDF) 137 Page - Freescale Semiconductor, Inc