W25X05CLZPIG datasheet(25/51 Pages) WINBOND

25 / 51 page

W25X05CL/10CL/20CL

Publication Release Date: March 23, 2012

- 25 -

Revision B

8.2.15 Sector Erase (20h)

The Sector Erase instruction sets all memory within a specified sector (4K-bytes) to the erased state

of all 1s (FFh). A Write Enable instruction must be executed before the device will accept the Sector

Erase Instruction (Status Register bit WEL must equal 1). The instruction is initiated by driving the /CS

pin low and shifting the instruction code “20h” followed a 24-bit sector address (A23-A0) (see Figure 2).

The Sector Erase instruction sequence is shown in figure 15.

The /CS pin must be driven high after the eighth bit of the last byte has been latched. If this is not

done the Sector Erase instruction will not be executed. After /CS is driven high, the self-timed Sector

Erase instruction will commence for a time duration of tSE (See AC Characteristics). While the Sector

Erase cycle is in progress, the Read Status Register instruction may still be accessed for checking the

status of the BUSY bit. The BUSY bit is a 1 during the Sector Erase cycle and becomes a 0 when the

cycle is finished and the device is ready to accept other instructions again. After the Sector Erase

cycle has finished the Write Enable Latch (WEL) bit in the Status Register is cleared to 0. The Sector

Erase instruction will not be executed if the addressed page is protected by the Block Protect (TB,

BP1, and BP0) bits (see Status Register Memory Protection table).

Figure 15. Sector Erase Instruction Sequence Diagram

/CS

CLK

(IO

Mode 0

Mode 3

Instruction (20h)

High Impedance

24-Bit Address

Mode 0

Mode 3

= MSB

W25X05CLZPIG 데이터시트(PDF) 25 Page - Winbond