AN2647 datasheet(20/34 Pages) STMICROELECTRONICS

20 / 34 page

Interfacing with synchronous memory

AN2647

20/34

2.1

PSRAM overview

The key functional block of the MT45W4M (MT45W4MW16BC), as shown in Figure 10 on

page 21, consists of a 4096K x 16 DRAM memory array, the Control Logic, the

Configuration registers and the Input/Output Buffer. The Bus Configuration Register (BCR)

controls the operating modes and timings of the MT45W4M.

2.1.1

Bus interface signals

The MT45W4M is usually connected to a non-multiplexed bus, with a 16-bit data bus and 23

address inputs. However, it can be configured to interface to a multiplexed bus like the

STR91xFA EMI bus. In addition to the standard SRAM control signals such as CE, OE, WE,

UB and LB, the PSRAM has four additional signals that are required for synchronous (burst)

mode operation and are described in Table 7.

Table 7.

PSRAM control signals

Signal

name

Type

Description

CLK

Input

Clock: Synchronizes the memory to the system operating frequency during

synchronous operations. When configured for synchronous operation, the address

is latched on the first rising CLK edge when ADV# is active. CLK must be static

LOW during asynchronous access READ and WRITE operations

ADV#

Input

Address valid: Indicates that a valid address is present on the address inputs.

Addresses can be latched on the rising edge of ADV# during asynchronous READ

and WRITE operations.

CRE

Input

Control register enable: When CRE is HIGH, WRITE operations load the RCR or

BCR registers, and READ operations access the RCR, BCR, or DIDR registers.

Wait

Output

Wait: Provides data-valid feedback during burst READ and WRITE operations.

WAIT is used to arbitrate collisions between refresh and READ/WRITE operations.

WAIT is asserted at the end of a row. WAIT is asserted and should be ignored

during asynchronous mode.

CE#

Input

Chip enable: Activates the device when LOW. When CE# is HIGH, the device is

disabled and goes into standby or deep power-down mode.

OE#

Input

Output enable: Enables the output buffers when LOW. When OE# is HIGH, the

output buffers are disabled.

WE#

Input

Write enable: Determines if a given cycle is a WRITE cycle. If WE# is LOW, the

cycle is a WRITE to either a configuration register or to the memory array.

LB#

Input

Lower byte enable. DQ[7:0]

UB#

Input

Upper byte enable. DQ[15:8]

AN2647 데이터시트(PDF) 20 Page - STMicroelectronics

AN2647 데이터시트(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

데이터시트 다운로드

링크 URL