AN4013 datasheet(21/37 Pages) STMICROELECTRONICS

21 / 37 page

DocID022500 Rev 4

21/37

AN4013

Timer synchronization

3.1

Timer system link

STM32 timers are linked together internally for timer synchronization or chaining. Each timer

has several internal trigger inputs and outputs. These signals allow the timer to be

connected with other timers.

Figure 4. Timer system link

3.2

Master configuration

When a timer is selected as a master timer, the corresponding trigger output signal is used

by the slave internal trigger (when configured). The trigger output can be selected from the

following list:



Reset: the UG bit from the EGR register is used as a trigger output (TRGO).



Enable: the counter enable signal is used as a trigger output (TRGO). It is used to start

several timers at the same time, or to control a window in which a slave timer is

enabled.



Update: the update event is selected as trigger output (TRGO). For example, a master

timer can be used as a prescaler for a slave timer.



Compare pulse: the trigger output sends a positive pulse when the CC1IF flag is to be

set (even if it was already high) as soon as a capture or a compare match occurs.



OC1Ref: OC1REF signal is used as trigger output (TRGO).



OC2Ref: OC2REF signal is used as trigger output (TRGO).



OC3Ref: OC3REF signal is used as trigger output (TRGO).



OC4Ref: OC4REF signal is used as trigger output (TRGO).

AN4013 데이터시트(PDF) 21 Page - STMicroelectronics