A5974D datasheet(35/46 Pages) STMICROELECTRONICS

35 / 46 page

DocID018774 Rev 2

35/46

A5974D

Application information

8.7

Positive buck-boost regulator

The device can be used to implement a step-up/down converter with a positive output

voltage.

The output voltage is given by:

Equation 37

where the ideal duty cycle D for the buck-boost converter is:

Equation 38

However, due to power losses in the passive elements, the real duty cycle is always higher

than this. The real value (that can be measured in the application) should be used in the

following formulas.

The peak current flowing in the embedded switch is:

Equation 39

while its average current is equal to:

Equation 40

This is due to the fact that the current flowing through the internal power switch is delivered

to the output only during the OFF phase.

The switch peak current must be lower than the minimum current limit of the overcurrent

protection (see Table 4 on page 6 for details) while the average current must be lower than

the rated DC current of the device.

As a consequence, the maximum output current is:

Equation 41

where ISW MAX represents the rated current of the device.

The current capability is reduced by the term (1 - D) and so, for example, with a duty cycle of

0.5, and considering an average current through the switch of 3 A, the maximum output

current deliverable to the load is 1.5 A.

VOUT

VIN

–

-------------



VOUT

VIN VOUT

------------------------------

ISW

ILOAD

–

---------------

IRIPPLE

--------------------

ILOAD

–

---------------

VIN



-----------

fSW

---------



ISW

ILOAD

–

---------------

IOUT MAX ISW MAX 1D

–







A5974D 데이터시트(PDF) 35 Page - STMicroelectronics

A5974D 데이터시트(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

데이터시트 다운로드

링크 URL