| 전자부품 데이터시트 검색엔진 |
|
ATPL00B 데이터시트(PDF) 97 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATPL00B 데이터시트(HTML) 97 Page - ATMEL Corporation |
|
97 / 152 page ![]() Atmel ATPL00B [datasheet] 43028A-ATPL - 9/12 97 10.3.2 FLAGS1 register Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 B it 0 FLAGS1 BYP -- -- ZER0_A NMDR RxFEC RX TX Name: FLAGS1 Address: 0xFE01 Reset: “00010000” This register holds a mode operation bit, some special purpose bits and the RX and TX flags to control the transmission and reception processes. The MCU has full access to this register. --: Reserved bit BYP: Bypass mode When this mode is enabled, the MAC logic is disabled and the MCU takes full control of the PLC modem „0‟: Bypass mode disabled „1‟: Bypass mode enabled ZER0_A: Errors allowed in preamble This field selects whether erroneous bits are allowed in preamble reception or not „0‟: No errors are allowed in preamble reception. A(1:0) field (see CTRL register in 10.3.1) sets the number of 0xA‟s expected to be received. If there is any erroneous bit in this preamble reception, the frame will be discarded. „1‟: Errors are allowed in preamble reception. The frame will be discarded only if the erroneous bits received in preamble exceed a threshold (see TH_PREAM register in 10.3.5). NMDR: No more data required This bit should be set by the MCU after the last byte of the payload is being sent or received through the DATA register. In FCS mode it would mean that the next field to be processed by the MAC is the FCS field. Setting the NMDR bit is only required in the following situations: a) Message transmissions with TX interrupt enabled. b) Message receptions in FCS mode with Viterbi algorithm disabled. „0‟: NMDR deasserted „1‟: NMDR asserted RxFEC: Receive FEC fields If this bit is set, FEC fields are also delivered by the MAC to the MCU by means of DATA register. If this bit is clear, the MAC delivers to the MCU only the data bytes. See DATA register section and “Operation Modes” chapter for more information about how the FEC bits are made accessible to the MCU. „0‟: Only data bytes are read by the MCU ‟1‟: Both data and FEC are read by the MCU |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |