56F8167 datasheet(42/184 Pages) FREESCALE

42 / 184 page

56F8367 Technical Data, Rev. 7.0

Freescale Semiconductor

Preliminary

4.2 Program Map

The operating mode control bits (MA and MB) in the Operating Mode Register (OMR) control the

Program memory map. At reset, these bits are set as indicated in Table 4-2. Table 4-4 shows the memory

map configurations that are possible at reset. After reset, the OMR MA bit can be changed and will have

an effect on the P-space memory map, as shown in Table 4-3. Changing the OMR MB bit will have no

effect.

The device’s external memory interface (EMI) can operate much like the 56F80x family’s EMI, or it can

be operated in a mode similar to that used on other products in the 56800E family. Initially, CS0 and CS1

are configured as PS and DS, in a mode compatible with earlier 56800 devices.

Eighteen address lines are required to shadow the first 192K of internal program space when booting

externally for development purposes. Therefore, the entire complement of on-chip memory cannot be

accessed using a 16-bit 56800-compatible address bus. To address this situation, the EMI_MODE pin can

be used to configure four GPIO pins as Address[19:16] upon reset (Software reconfiguration of the highest

address lines [A20-23] is required if the full address range is to be used.)

The EMI_MODE bit also affects the reset vector address, as provided in Table 4-4. Additional pins must

be configured as address or chip select signals to access addresses at P: $10 0000 and above.

Note: Program RAM is NOT available on the 56F8167 device.

Table 4-2 OMR MB/MA Value at Reset

OMR MB =

Flash Secured

State1, 2

1. This bit is only configured at reset. If the Flash secured state changes, this will not be reflected in MB until the next reset.

2. Changing MB in software will not affect Flash memory security.

OMR MA =

EXTBOOT Pin

Chip Operating Mode

Mode 0 – Internal Boot; EMI is configured to use 16 address lines; Flash Memory is

secured; external P-space is not allowed; the EOnCE is disabled

Not valid; cannot boot externally if the Flash is secured and will actually configure to

00 state

Mode 0 – Internal Boot; EMI is configured to use 16 address lines

Mode 1 – External Boot; Flash Memory is not secured; EMI configuration is

determined by the state of the EMI_MODE pin

Table 4-3 Changing OMR MA Value During Normal Operation

OMR MA

Chip Operating Mode

Use internal P-space memory map configuration

Use external P-space memory map configuration – If MB = 0 at reset, changing this bit has no effect.

56F8167 데이터시트(PDF) 42 Page - Freescale Semiconductor, Inc