STM8S datasheet(173/467 Pages) STMICROELECTRONICS

173 / 467 page

DocID14587 Rev 14

173/467

RM0016

16-bit advanced control timer (TIM1)

261

The output compare mode is defined by the OCiM bits in the TIM1_CCMRi registers. The

active or inactive level polarity is defined by the CCiP bits in the TIM1_CCERi registers.

The TIM1_CCRi registers can be programmed with or without preload registers using the

OCiPE bits in the TIM1_CCMRi registers.

In output compare mode, the UEV has no effect on the OCiREF and OCi output. The timing

resolution is one count of the counter. Output compare mode can also be used to output a

single pulse.

Procedure

Select the counter clock (internal, external, or prescaler).

Write the desired data in the TIM1_ARR and TIM1_CCRi registers.

Set the CCiIE bits if an interrupt request is to be generated.

Select the output mode as follows:

–

Write OCiM = 011 to toggle the OCi output pin when CNT matches CCRi

–

Write OCiPE = 0 to disable the preload register

–

Write CCiP = 0 to select active high polarity

–

Write CCiE = 1 to enable the output

Enable the counter by setting the CEN bit in the TIMx_CR1 register

The TIM1_CCRi registers can be updated at any time by software to control the output

waveform, provided that the preload registers are not enabled (OCiPE = 0). Otherwise, the

TIMx_CCRi shadow registers are updated only at the next UEV (see example in Figure 69.

Figure 69. Output compare mode, toggle on OC1

STM8S 데이터시트(PDF) 173 Page - STMicroelectronics