STM8S datasheet(215/467 Pages) STMICROELECTRONICS

215 / 467 page

DocID14587 Rev 14

215/467

RM0016

16-bit advanced control timer (TIM1)

261

17.7.30

Break register (TIM1_BKR)

Address offset: 0x1D

Reset value: 0x00

654

3210

MOE

AOE

BKP

BKE

OSSR

OSSI

LOCK

Bit 7 MOE: Main output enable

This bit is cleared asynchronously by hardware as soon as the break input is active. It is set by

software or automatically depending on the AOE bit. It acts only on the channels which are

configured in output.

0: OC and OCN outputs are disabled or forced to idle state

1: OC and OCN outputs are enabled if their respective enable bits are set (CCiE in TIM1_CCERi

registers).

See OC/OCN enable description for more details (Section 17.7.13 on page 205).

Bit 6 AOE: Automatic output enable

0: MOE can be set only by software

1: MOE can be set by software or automatically at the next UEV (if the break input is not active)

Note: This bit can no longer be modified while LOCK level 1 has been programmed (LOCK bits in the

TIM1_BKR register).

Bit 5 BKP: Break polarity

0: Break input BKIN is active low

1: Break input BKIN is active high

Note: This bit can no longer be modified while LOCK level 1 has been programmed (LOCK bits in the

TIM1_BKR register).

Bit 4 BKE: Break enable

0: Break input (BKIN) disabled

1: Break input (BKIN) enabled

Note: This bit can no longer be modified while LOCK level 1 has been programmed (LOCK bits in the

TIM1_BKR register).

STM8S 데이터시트(PDF) 215 Page - STMicroelectronics