STM8S datasheet(316/467 Pages) STMICROELECTRONICS

316 / 467 page

Inter-integrated circuit (I2C) interface

RM0016

316/467

DocID14587 Rev 14

21.7.12

Clock control register high (I2C_CCRH)

Address offset: 0x0C

Reset value: 0x00

Note:

The CCR registers must be configured only when the I²C is disabled (PE=0).

fMASTER = multiple of 10 MHz is required to generate Fast clock at 400 kHz. fMASTER ≥ 1

MHz is required to generate Standard clock at 100 kHz.

654

3210

F/S

DUTY

Reserved

CCR[11:8]

Bit 7 F/S: I2C master mode selection

0: Standard mode I2C

1: Fast mode I2C

Bit 6 DUTY: Fast mode duty cycle

0: Fast mode tlow/thigh = 2

1: Fast mode tlow/thigh = 16/9 (see CCR)

Bits 5:4 Reserved

Bits 3:0 CCR[11:8]: Clock control register in Fast/Standard mode (Master mode)

Controls the SCLH clock in master mode.

– Standard mode:

Period(I2C) = 2 * CCR * tMASTER

thigh = CCR * tMASTER

tlow = CCR * tMASTER

– Fast mode:

If DUTY = 0:

Period(I2C) = 3 * CCR * tMASTER

thigh = CCR * tMASTER

tlow = 2 * CCR * tMASTER

If DUTY = 1: (to reach 400 kHz)

Period(I2C) = 25 * CCR * tMASTER

thigh = 9 * CCR * tMASTER

tlow = 16 * CCR * tMASTER

For instance: in standard mode, to generate a 100 kHz SCL frequency:

If FREQR = 08, tMASTER = 125 ns so CCR must be programmed with 0x28

(0x28 <=> 40 x 125 ns = 5000 ns.)

Note: thigh = tr(SCL) + tw(SCLH). See device datasheet for the definitions of parameters

tlow = tf(SCL) + tw(SCLL). See device datasheet for the definitions of parameters

The real frequency may differ due to the analog noise filter input delay.

STM8S 데이터시트(PDF) 316 Page - STMicroelectronics

STM8S 데이터시트(HTML) 316 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL