STM32H723VG datasheet(26/227 Pages) STMICROELECTRONICS

26 / 227 page

Functional overview

STM32H723xE/G

26/227

DS13313 Rev 2

3.7.3

Voltage regulator

The same voltage regulator supplies the 3 power domains (D1, D2 and D3). D1 and D2 can

be independently switched off.

Voltage regulator output can be adjusted according to application needs through 6 power

supply levels:

•

Run mode (VOS0 to VOS3)

–

Scale 0: boosted performance

–

Scale 1: high performance

–

Scale 2: medium performance and consumption

–

Scale 3: optimized performance and low-power consumption

•

Stop mode (SVOS3 to SVOS5)

–

Scale 3: peripheral with wakeup from Stop mode capabilities (UART, SPI, I2C,

LPTIM) are operational

–

Scale 4 and 5 where the peripheral with wakeup from Stop mode is disabled. The

peripheral functionality is disabled but wakeup from Stop mode is possible through

GPIO or asynchronous interrupt.

3.8

Low-power strategy

There are several ways to reduce power consumption on STM32H723xE/G:

•

Decrease the dynamic power consumption by slowing down the system clocks even in

Run mode and by individually clock gating the peripherals that are not used.

•

Save power when the CPU is idle, by selecting among the available low-power modes

according to the user application needs. This allows the best compromise between

short startup time and low power consumption to be achieved, according to the

available wakeup sources.

The devices feature several low-power modes:

•

CSleep (CPU clock stopped)

•

CStop (CPU sub-system clock stopped)

•

DStop (Domain bus matrix clock stopped)

•

Stop (System clock stopped)

•

DStandby (Domain powered down)

•

Standby (System powered down)

CSleep and CStop low-power modes are entered by the MCU when executing the WFI

(Wait for Interrupt) or WFE (Wait for Event) instructions, or when the SLEEPONEXIT bit of

the Cortex®-Mx core is set after returning from an interrupt service routine.

A domain can enter low-power mode (DStop or DStandby) when the processor, its

subsystem and the peripherals allocated in the domain enter low-power mode.

If part of the domain is not in low-power mode, the domain remains in the current mode.

Finally the system can enter Stop or Standby when all EXTI wakeup sources are cleared

and the power domains are in DStop or DStandby mode.

STM32H723VG 데이터시트(PDF) 26 Page - STMicroelectronics

STM32H723VG 데이터시트(HTML) 26 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL