HC705V8GRSSLASHD datasheet(13/172 Pages) NXP

13 / 172 page

SECTION 1: GENERAL DESCRIPTION

Page 2

MC68HC705V8 Specification Rev. 2.1

NOTE:

A line over a signal name indicates an active low signal. For example,

RESET is active high and RESET is active low. Any reference to voltage,

current, or frequency specified in the following sections will refer to the

nominal values. The exact values and their tolerance or limits are

specified in SECTION 17 ELECTRICAL SPECIFICATIONS.

1.2

MASK OPTIONS

The following mask options are available:

•

Sensitivity on IRQ Interrupt, Edge- and Level-Sensitive or Edge-Sensitive

Only

•

Selectable COP Watchdog System

•

Selectable Low Voltage Reset (LVR) to Hold CPU in Reset

•

Selectable STOP Instruction Disable

•

Selectable on-chip power supply regulator disconnect

•

Selectable option to allow regulator wakeup on a rising edge of the MDLC

Bus

•

Selectable option to tie the regulator output to VSS when disabled

These mask options are provided through individual bits within the Mask Option Register

which is located and programmed as part of the EPROM array.

1.3

PIN ASSIGNMENTS

The MC68HC705V8 requires 64 bond pads for all I/O and power supply functions. The

device is available in a 56-pin SDIP package where the 8 A/D channels associated with

Port E are not bonded out (AN8 through AN15). The device is also available in the 68 pin

PLCC and 64-pin QFP packages.

The pin out for the 56-pin SDIP, the 68-pin PLCC, and the 64-pin QFP packages are shown

in the following figures. The pad positions are also shown in the following figures.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705V8GRS/D 데이터시트(PDF) 13 Page - NXP Semiconductors