WM8580 datasheet(19/97 Pages) WOLFSON

19 / 97 page

Production Data

WM8580

PD Rev 4.3 August 2007

With CONTREAD set, a single read-only register can be read back by writing to any other register or

to a dummy register. The register to be read is determined by the READMUX[2:0] bits. When a write

to the device is performed, the device will respond by returning the status byte in the register

selected by the READMUX register bits. This 3-wire interface read back method using a write access

is shown in Figure 7

BIT

LABEL

DEFAULT

DESCRIPTION

2:0

READMUX

[2:0]

000

Determines which status register

is to be read back:

000 = Error Register

001 = Channel Status Register 1

010 = Channel Status Register 2

011 = Channel Status Register 3

100 = Channel Status Register 4

101 = Channel Status Register 5

110 = S/PDIF Status Register

CONTREAD

Continuous Read Enable.

0 = Continuous read-back mode

disabled

1 = Continuous read-back mode

enabled

R52

READBACK

34h

READEN

Read-back mode enable.

0 = read-back mode disabled

1 = read-back mode enabled

Table 9 Read-back Control Register

The 3-wire interface readback protocol is shown below. Note that the SDO pin is tri-state unless CSB

is held low; therefore CSB must be held low for the duration of the read.

Figure 7 3-Wire SPI Compatible Interface Continuous Readback

If CONTREAD is set to zero, the user can read back directly from the register by writing to the

Figure 8 below.

WM8580 데이터시트(PDF) 19 Page - Wolfson Microelectronics plc

WM8580 데이터시트(HTML) 19 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

데이터시트 다운로드

링크 URL