TMP86FS28DFG datasheet(180/272 Pages) TOSHIBA

180 / 272 page

Page 168

12. Asynchronous Serial interface (UART1 )

12.9 Status Flag

TMP86FS28DFG

Figure 12-7 Generation of Overrun Error

Note:Receive operations are disabled until the overrun error flag UART1SR<OERR> is cleared.

12.9.4 Receive Data Buffer Full

Loading the received data in RD1BUF sets receive data buffer full flag UART1SR<RBFL> to "1". The

UART1SR<RBFL> is cleared to “0” when the RD1BUF is read after reading the UART1SR.

Figure 12-8 Generation of Receive Data Buffer Full

Note:If the overrun error flag UART1SR<OERR> is set during the period between reading the UART1SR and read-

ing the RD1BUF, it cannot be cleared by only reading the RD1BUF. Therefore, after reading the RD1BUF,

read the UART1SR again to check whether or not the overrun error flag which should have been cleared still

remains set.

12.9.5 Transmit Data Buffer Empty

When no data is in the transmit buffer TD1BUF, that is, when data in TD1BUF are transferred to the transmit

shift register and data transmit starts, transmit data buffer empty flag UART1SR<TBEP> is set to “1”. The

UART1SR<TBEP> is cleared to “0” when the TD1BUF is written after reading the UART1SR.

Final bit

Stop

Shift register

xxxx0*

1xxxx0

yyyy

xxx0**

RXD1 pin

UART1SR<OERR>

INTRXD1 interrupt

After reading UART1SR then

RD1BUF clears OERR.

RD1BUF

UART1SR<RBFL>

Final bit

Stop

Shift register

xxxx0*

1xxxx0

xxxx

yyyy

xxx0**

RXD1 pin

UART1SR<RBFL>

INTRXD1 interrupt

RD1BUF

After reading UART1SR then

RD1BUF clears RBFL.

TMP86FS28DFG 데이터시트(PDF) 180 Page - Toshiba Semiconductor

TMP86FS28DFG 데이터시트(HTML) 180 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL