STA680 datasheet(29/48 Pages) STMICROELECTRONICS

29 / 48 page

DS5877 Rev 13

29/48

STA680

Digital I/O and memory interfaces

5.2

Base-band I2S interface

The STA680 has two digital Base-Band Interfaces (BBI1 and BBI2).

The tuner receives the analog signal from the antenna, samples it, performs down

conversion and channel selection, and transmits the digital base-band stream to the

STA680 by means of BB1 and BB2.

Each BB interface consists of maximum four wires: up to two serial data lines I/Q (or one

single data lines where I and Q data are multiplexed), one bit clock line and one frame clock

line. The serial data is always transmitted with the MSB first and a 16-bit word length. The

complex base-band signal needs to be at zero IF.

Most common data rates are supported by using the internal base-band sample rate

converter. The allowed base-band interface data rates are:



650 kS/s,



675 kS/s,



744.1875 kS/s



912 kS/s.

Table 6. describes the pin functionality of both BBI1 and BBI2.

The base-band interface supports the modes shown in Figure 9 Timing information for the

protocols shown in Figure 9 is detailed in Table 7.

Table 6. Baseband interfaces pin list

Pin name

Designation

Type

BB1_WS

Primary baseband interface word strobe

BB1_BCK

Primary baseband interface bit clock

BB1_I

Primary baseband interface serial I data (or Primary baseband

data I/Q multiplexed)

BB1_Q

Primary baseband interface serial Q data

BB2_WS

Secondary baseband interface word strobe

BB2_BCK

Secondary baseband interface bit clock

BB2_I

Secondary baseband interface serial I data (or Secondary

baseband data I/Q multiplexed)

BB2_Q

Secondary baseband interface serial Q data

STA680 데이터시트(PDF) 29 Page - STMicroelectronics

STA680 데이터시트(HTML) 29 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

데이터시트 다운로드

링크 URL