ST7FLCD1 datasheet(30/95 Pages) STMICROELECTRONICS

30 / 95 page

Flash Program Memory

ST7FLCD1

30/95

(> 1 k

Ω) , no additional components are needed. In any case, the user must ensure that an

external reset is not generated by the application during the ICC session.

3. The use of Pin 7 of the ICC connector depends on the Programming Tool architecture. This pin

must be connected when using most ST programming tools (it is used to monitor the

application power supply). Please refer to the Programming Tool manual.

5.6

In-Application Programming (IAP)

This mode uses a Boot Loader program previously stored in Sector 0 by the user (in ICP mode or by

plugging the device in a programming tool).

This mode is fully-controlled by user software. This allows it to be adapted to the user application,

(user-defined strategy for entering programming mode, choice of communications protocol used to

fetch the data to be stored, etc.). For example, it is possible to download code from either DDC

interface and program it in the Flash memory. IAP mode can be used to program any of the Flash

sectors except Sector 0, which is write/erase protected to allow recovery in case errors occur during

the programming operation.

5.7

FLASH CONTROL/STATUS REGISTER (FCSR)

Read/Write

Reset Value: 0000 0000 (00h)

Figure 12: Typical ICP Interface

765

432

000

ICC Connector

HE10 Male-type Connector

Application

Power Supply

Programming Tool

ICC Connector

Application Board

ICC Cable

Optional

(See Note 3)

10k

Ω

ST7

CL2

CL1

See Note 1

See Note 2

Application

Reset Source

I/O

Application

ST7FLCD1 데이터시트(PDF) 30 Page - STMicroelectronics

ST7FLCD1 데이터시트(HTML) 30 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95

데이터시트 다운로드

링크 URL