M58LR128KB855 datasheet(47/110 Pages) NUMONYX

47 / 110 page

M58LR128KT, M58LR128KB, M58LR256KT, M58LR256KB

Read modes

47/111

7.2

Synchronous burst read mode

In synchronous burst read mode the data is output in bursts synchronized with the clock. It is

possible to perform burst reads across bank boundaries.

Synchronous burst read mode can only be used to read the memory array. For other read

operations, such as read Status Register, read CFI , and read electronic signature, single

synchronous read or asynchronous random access read must be used.

In synchronous burst read mode the flow of the data output depends on parameters that are

configured in the Configuration Register.

A burst sequence starts at the first clock edge (rising or falling depending on valid Clock

edge bit CR6 in the Configuration Register) after the falling edge of Latch Enable or Chip

Enable, whichever occurs last. Addresses are internally incremented and data is output on

each data cycle after a delay which depends on the X latency bits CR13-CR11 of the

Configuration Register.

The number of words to be output during a synchronous burst read operation can be

configured as 4 words, 8 words, 16 words or continuous (burst length bits CR2-CR0). The

data can be configured to remain valid for one or two clock cycles (data output configuration

bit CR9).

The order of the data output can be modified through the wrap burst bit in the Configuration

boundary (wrap) or overcome the boundary (no wrap).

The WAIT signal may be asserted to indicate to the system that an output delay will occur.

This delay depends on the starting address of the burst sequence and on the burst

configuration.

WAIT is asserted during the X latency, the WAIT state and at the end of a 4, 8 and 16 word

burst. It is only de-asserted when output data are valid. In continuous burst read mode a

WAIT state occurs when crossing the first 16 word boundary. If the starting address is

aligned to the burst length (4, 8 or 16 words) the wrapped configuration has no impact on

the output sequence.

The WAIT signal can be configured to be active Low or active High by setting CR10 in the

Configuration Register.

See Table 25: Synchronous read AC characteristics and Figure 11: Synchronous burst read

AC waveforms for details.

M58LR128KB855 데이터시트(PDF) 47 Page - Numonyx B.V