24

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

WATER BUTT CONNECTION

This machine has the ability to draw its own water, meaning you can use water not

under pressure, such as rainwater collected in a water butt. To do this you must carry

out the following procedure.

1. Attach the filter to the end of the pipe

supplied.

2. Place the filter into the water butt.

3. Remove the hose adaptor and

replace it with the inlet connector

supplied.

4. Connect the pick-up pipe to the

pressure washer as shown.

• Tighten securely

5. Twist open the suction valve shown.

6. Start the power washer. See Starting

your Power Washer on page 18

onwards.

• Water is ejected from the nozzle.

7. When the water spray being ejected

is consistent and at high pressure,

close the suction valve.

8. Use the pressure washer as normal.

NOTE: DO NOT LET THE PRESSURE WASHER RUN DRY.