28

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

2. Remove the second nut shown and

remove the filter.

3. Make sure that the air filter is clean and not damaged.

• If the air filter is damaged contact CLARKE parts department for a

replacement.

• If the filter is dirty, wash it in a solution of warm water and mild detergent

and rinse thoroughly. Leave the filter to dry completely; before immersing

the filter in clean engine oil and squeeze the filter to remove excess oil.

4. Replace the filter and the air filter cover.

STORAGE

ENGINE

See the separate engine manual supplied for information regarding the

storage procedure.

PUMP

1. Drain all water from the high pressure hose, coil it and store it on the hose holder,

located on the side of the power washer.

2. Drain all water from the spray gun and spray wand by holding the gun/wand

vertically with the nozzle pointing down, and pulling the trigger. Store in the gun

holder on the side of the power washer.

3. Store all other parts so that they are protected from damage.

4. Protect the power washer from freezing conditions to prevent damage to the

hoses, valves and pump.