ST40RA datasheet(22/94 Pages) STMICROELECTRONICS

22 / 94 page

ADCS 7260755H

STMicroelectronics

22/94

ST40RA

5 System configuration

5.8.1

Memory bridge control signals

Each memory bridge has seven control signals as defined in

Table 10.

5.8.2

Memory bridge status

The memory bridge control signals are looped back to the ST40RA comms subsystem SYS_STAT1

Section 5.9.4.1:

SYSCONF.SYS_STAT1. on page 26.

5.8.3

Changing control of a memory bridge

At reset all these bridges are set to be synchronous. After reset and boot the function of these

memory bridges can be changed. See

Section 5.9.4: SYSCONF registers on page 26. The

procedure for changing the control of a memory bridge is given below.

Ensure no initiators are accessing the subsystem the bridge is connected to and ensure the

subsystem cannot initiate any requests to the SuperHyway.

Stop the clock to the subsystem.

Change the memory bridge configuration using the SYS_CONF.SYS_CON1 register as

detailed in

Table 10.

Restart the clock to the subsystem and reinitialize the system.

Bridge control bit field

Control name

Control function

1:0

MODE[1:0]

00: Sync (bypass) bridge

01: Semisync with no retime registers

10: Semisync with one retime register

11: Async with two retime registers

4:2

LATENCY[2:0]

Sets FIFO latency from 0 to 7 cycles.

SW_RESET

0: Software reset inactive

1: Software reset active

STROBE

The above control signals are latched in the bridge on the rising

edge of this strobe bit

Table 10: Memory bridge control signals

ST40RA 데이터시트(PDF) 22 Page - STMicroelectronics

ST40RA 데이터시트(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94

데이터시트 다운로드

링크 URL